PDA

View Full Version : Radio Removal

tp2400
03-18-2008, 10:24 AM
I'm getting ready to take the stock shaker system out of my 05 coupe, is there any special tool besides the ford tool to get the radio out. Do I have to take any part of the dash apart?
XCELER8
03-18-2008, 10:36 AM
Here is the special tool needed

http://ozort.org/images/kryptonite-crowbar.jpg
tp2400
03-18-2008, 10:41 AM
Here is the special tool needed

http://ozort.org/images/kryptonite-crowbar.jpg
:rotfl::rotfl::rotfl:
sktrstangs
03-18-2008, 11:09 AM
This will help you out with removing the radio for I have done this. I have attached instructions for you.
tp2400
03-18-2008, 11:29 AM
This will help you out with removing the radio for I have done this. I have attached instructions for you.

This is awesome! Thanks!:applause:
sktrstangs
03-18-2008, 11:40 AM
Always ready to lend a hand to my fellow Mustangers! Good luck with the radio removal, it's not that hard to do actually.
tp2400
03-18-2008, 11:46 AM
Always ready to lend a hand to my fellow Mustangers! Good luck with the radio removal, it's not that hard to do actually.

Do the center stack wings just pop out?
sktrstangs
03-18-2008, 11:49 AM
Mine did...They snap into place there's no screws attached.
tp2400
03-18-2008, 01:31 PM
Mine did...They snap into place there's no screws attached.


I'm not good with snaps, hopefully I don't break any:poke:
RedFire2005
03-22-2008, 04:02 PM
It's pretty strong plastic. I had the same worry but it all went well. I don't encourage use of the above pry bar though!
Midnight Crawler
03-22-2008, 11:07 PM
i have had that part of my dash out about ten times its a piece of cake