heater block off kit?

[spankmaster]

Was looking to see if there was a kit out there to plug the holes in the firewall when you remove the heater?

[speedfreak87]

Not that I know of. but I'm sure they make grommets that would fit in the holes.

[spankmaster]

I am just going to cover them with sheet metal it I need too.

[speedfreak87]

check harborfreight.com, they have lods of grommets and stuff, I'm sure they would sell something that fits.

[spankmaster]

I just went and got some sheet metal and cut it out then screwed it over the holes.

[speedfreak87]

or you could do that. lol!

[spankmaster]

it worked out pretty good. I just hope I will pass tech. Just got the motor installed today. Hoping to run her at FFW in october.

[speedfreak87]

did you seal it with anything? or just screw the plates on?

[spankmaster]

I put some seal around the holes then screwed on the plates. I did the same thing with my 69 and didn't have a problem with tech.

[speedfreak87]

you should be ok then.