PDA

View Full Version : My mod list

duane v
08-13-2007, 08:33 PM
:wave: ....DA snake boy!!!!


My mods

.020 over Arias Pistons 11.5:1 cpr
Forged Cunningham Connecting Rods
Ported lower intake
Crower stage 3 custom reground cams
Custom motorcycle valvesprings
IMRC deletes
Smoothed and polished inner upper intake
Accufab Elliptical throttle body
UPR Power Pipe
90mm LMAF
42 lbs injectors
Aviator fuel pump
Mezeire electric water pump
SVO pullies
A/C delete
Canton Aluminum overflow tank
Kenne Bell BAS
Accel coil packs
Taylor 10.4 mm thunderbolt spark plugs
Stainless Steel Watson Eng. long tube headers
3” exhaust
3” dynomax race bullet muffs dumped
Mcleod twin disk clutch
Mcleod billet steel flywheel
Lakewood scatter shield
TKO plus tranny
FMS aluminum drive shaft
Moser 31sSpline full spool, 9” housing ends
4.88 gear
Moser aluminum girdle
D&D chromoly tubular k-member and a-arms
D&D coil-overs w/14” 150 rate springs
90/10 Lakewood struts
50/50 Lakewood shocks
Rear air bags
Chromoly HANS RACECRAFT 8PT CAGE
Chromoly HANS RACECRAFT custom sub frame connectors
Chromoly HANS RACECRAFT shock tower brace
Tuned by Shawn Ellis SoCalTuning
BlKvNm
08-13-2007, 08:44 PM
Holy list....just checked out your pic too...very nice :blkvnm:
Dirty_SOHC
08-14-2007, 08:43 AM
That thing sounds like a beast :mick:
baby_girl06
08-14-2007, 09:01 AM
That thing sounds like a beast :mick:
:blkvnm:
StangSteph
08-14-2007, 01:39 PM
That thing sounds like a beast :mick:
:+1:
speedfreak87
08-14-2007, 10:44 PM
DAMN!

but motorcycle springs? they work?
duane v
08-14-2007, 11:02 PM
DAMN!

but motorcycle springs? they work?
they are custom valve springs I recieved from AEW. They look very similar to the Crowers, and they handle revs to 7500 rpm no problem...they say they will live at 9000 rpm, but everything else on my stang will surely die :omg: ......Still I do not like reving my stang that high, the TKO shifts fine on the rollers, but I just dont think it will live bangin the gears on pavement at 7500 rpm...DA snake boy!!!
grendel
08-14-2007, 11:14 PM
nice list
speedfreak87
08-15-2007, 02:17 PM
they are custom valve springs I recieved from AEW. They look very similar to the Crowers, and they handle revs to 7500 rpm no problem...they say they will live at 9000 rpm, but everything else on my stang will surely die :omg: ......Still I do not like reving my stang that high, the TKO shifts fine on the rollers, but I just dont think it will live bangin the gears on pavement at 7500 rpm...DA snake boy!!!


Gotcha! just thought it was a little odd.. but hey, if it works, why not. :mick: